My Vantage Connect is not uploading data. How to fix that?

Try these steps with your Vantage Connect:

  • Make sure status LED is showing normal function, otherwise the device has not registered on the network.
  • Check power to the weather station. Make sure all cables are securely plugged in.
  • Measure battery power with volt meter (should measure at 6 volts and above). If the battery power is less than 6 volts, please make note of the voltage and contact Technical Support.
  • Repower by unplugging the main power cable, waiting one minute, then plugging it in again.

If data still is not uploading, contact Technical Support.

How well did this answer your question?

Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)