How do I add an external antenna?

If you are using your IP Gateway in a Universal Shelter, remove the solid grommet from one of the holes in the base of the shelter. Run the antenna cable up through this hole. Use the split grommet with a round hole that was included with the antenna to seal the hole. Then follow the steps below.

  1. Screw the end antenna cable into the connector on the side of the IP Gateway
  2. Use the EnviroMonitor app on your smartphone to set up the antenna: In the app, navigate to this Gateway
  3. Click the menu icon in the upper right corner
  4. Click “About
  5. Click: “Antenna: Internal.”
  6. Choose “External.”
  7. Click Save.

How well did this answer your question?

Powered by HelpDocs (opens in a new tab)